Below you'll find the steps you need to follow to restart a Range server and ensure the Range monitors update correctly.

1. Locate the server: 
   • It is the third device from the bottom of the rack and has a silver grill on the front.
     
     
2. Power off the server: 
   • Press and hold the marked power button for 5 seconds. The lights will briefly go out and then start flashing again.
3. Wait: 
   • Leave the server in this state for 30 seconds without pressing anything.
4. Power on the server: 
   • After 30 seconds, press the same power button once (do not hold it). The server will begin to boot up.
5. Boot time: 
   • Wait about 5 minutes for the server to fully boot up.
6. Restart the Range monitors: 
   • Once the server is running, go to the Range monitors and restart them so they can fetch the updated information from the server.